scinco Mega-800 - Page 56

55 Mega-800 SCINCO
A: Instrument main menu B: Main menu of DNA/Protein analysis
Fig. 6.1 Gain access to DNA/Protein analysis
When you exit the DNA/Protein analysis mode, the system will prompt the user with the information
―Delete all the data? (YES: ENTER, NO: CLE)‖
Press ，it will return to the main menu and the measurement data will be lost. Press ，it
will return to the main menu of DNA/Protein analysis, and prompt ―press START to measure‖, then
you can continue on DNA/Protein analysis.
The following paragraphs introduce the main menu of DNA/Protein analysis:
Fig. 6.2 Main menu of DNA/Protein analysis
① DNA/Prot” here means DNA/Protein analysis, current working mode;“260nm” and
―230nm‖ refers to current working wavelength;
② Working area: Measurement results are shown in the table. It can show maximum 9
groups of measurment results each time.
③ Information indication area: The current information is prompting the user to press
to begin measurement.
④ Time display area: Time in the above picture is eight thirty four on April 15.
Note:
Please print out the measurement data before returning to the main menu, otherwise, the data will be
lost.