MultiExact Gas Analyser 5 – Installation and set-up
1. Analyser
2. Slide inner section
3. M5 pan head screws (3 off)
4. M4 counter sunk screws (4 off)
5. Slide outer section
6. M6 cage nuts (2 off)
7. M6 waisted screws (2 off)
8. Rear rack enclosure flange
9. M4 nut, washer and locking washer
(2 off)
10. Slide support bracket (rear)
11. Slide support clamp (rear)
12. Slide support clamp (front)
13.
M4 Nut, washer and locking washer
(2 off)
14. Slide support bracket (front)
15. M6 cage nuts (4 off)
16. Front rack enclosure flange
17. M6 waisted screws (2 off)
18. Plastic cup washers (2 off)
19. M6 pan-head screws (2 off)
Figure 10 – Install the analyser in a rack enclosure (with a slide)
05410001A / Revision 6 25
To Next Page
Loading...
