Servomex SERVOPRO MultiExact - Page 50

5 – Installation and set-up MultiExact Gas Analyser
Sample gas measurement
Pre-warning period
Inerting phase
Flushing phase
Auto calibration (low)
Flushing phase
Auto calibration (high)
Inerting phase
Flushing phase
Sample gas measurement
Figure 28 – Typical automatic calibration sequence
Time
Initiate auto calibration
Service in progress (SIP) status on
Route calibration gas 1
into
the analyser (Tx1)
Route calibration gas 2
into
the analyser (Tx1)
Route calibration gas 1
into
the analyser (Tx1)
Route sample gas
into
the analyser (Tx1)
Service in progress (SIP) status off
44 05410001A / Revision 6