5
Startup
Setting the EtherCAT®/SBusPLUS ID
Operating Instructions – MOVIDRIVE
®
modular
155
5.2 Setting the EtherCAT
®
/SBus
PLUS
ID
Setting the
EtherCAT®/
SBusPLUS
ID
The hexadecimal switches S1 and S2 must be set to "0".
5.3 Startup requirements
The following conditions apply to startup:
• You installed the application inverter correctly both mechanically and electrically.
• You configured the application inverter and connected drives correctly.
• Safety measures prevent accidental drive startup.
• Safety measures prevent danger to persons or machines.
Required hardware:
• PC or laptop with Ethernet interface.
• Standard Ethernet cables for connection between PC and MOVI‑C
®
CONTROLLER.
• MOVI‑C
®
CONTROLLER with completed startup
Required software:
• Engineering software MOVISUITE
®
standard from SEW‑EURODRIVE.
24748536/EN – 11/2017
To Next Page
Loading...