MX-M264U ADJUSTMENTS AND SETTINGS 5 – 21
STOP:
Reads the density of 3 - 7 mm area from leading edge of document,
decides the output image density according to the density of that
part. (The output image density is constant at whole area.)
REALTIME:
Reads the density of width of the document one by one, decides
the output image density according to the density of each part of
the document. (The output image density may be not constant at
whole area.)
PRESCAN:
Once the densities on the document surface are scanned, the out-
put image density is determined according to the average of the
scanned densities. (The output image density is even for all the
surface.)
AE WIDTH FULL:
Document density reading area in monochrome auto mode is 3 - 7
mm (leading edge of document) x Document width. No relationship
to PRESCAN MODE
AE WIDTH PART:
Document density reading area in monochrome auto mode is 3 - 7
mm (leading edge of document) x 100 mm (width). No relationship
to PRESCAN MODE
Operation in monochrome auto copy mode:
When the density of the document of the read area is light, output
image density is increased by control. When the density of the doc-
ument of the read area is dark, output image density is decreased
by control.
8-B (3)
Document low density image density
reproduction adjustment in the automatic
monochrome (Copy/Scan/FAX) mode
(No need to adjust normally) (Background
density adjustment in the scanning section)
Use for the reproducibility adjustment of document background
density in monochrome auto copy mode.
This adjustment is required in the following cases.
* When there is a desire not to reproduce the background of the
document. When there is a desire to reproduce the low density
image of the document.
* When there is request from the user.
1) Enter the SIM 46-32 mode.
2) Select the adjustment mode with the scroll key.
3) Enter the adjustment value with 10-key and press [OK] key.
When the adjustment value is increased, reproducibility of the
background and the low density image is increased. When the
adjustment value is decreased, reproducibility of the back-
ground and the low density image is decreased.
3to 7mm
3to 7mm
100mm
100mm
3to 7mm
Document table/RSPF mode
Document table mode
RSPF mode
AE WIDTH = FULL
AE WIDTH = PART
AE WIDTH = PART
Document density detection area
Display/Item Content Set value Default
A COPY : OC Copy mode (for OC) 1 - 250 196
B COPY : RSPF Copy mode (for RSPF) 1 - 250 196
C SCAN : OC Scanner mode (for OC) 1 - 250 196
D SCAN : RSPF Scanner mode (for RSPF) 1 - 250 196
E FAX : OC FAX mode (for OC) 1 - 250 196
F FAX : RSPF FAX mode (for RSPF) 1 - 250 196
OK
10-key
㩷
ǂǂǂ6,08/$7,21
ǂǂ12
&/26(
7(67
/,0,72)$(5($&7,216(77,1*
To Next Page
Loading...
Need help?
General
