MX-M264U SIMULATION 6 – 1
MX-M264U
Service Manual
[6] SIMULATION
1. General and purpose
The simulation mode has the following functions, to display the
machine operating status, identify the trouble position and causes
in an earlier stage, and to efficiently setup and adjust the machine
for improved serviceability.
1) Various adjustments
2) Setting of the specifications and functions
3) Canceling troubles
4) Operation check
5) Counters check, setting, clear
6) Machine operating conditions (operation hysteresis), data
check, clear.
7) Various (adjustments, setting, operation, counters, etc.) data
transport.
The operating procedures and displays depend on the design of
the operation panel of the machine.
2. Starting the simulation
Entering the simulation mode
1) Machine in Copy mode: Select Program key ï‚® Asterisk (*) key
ï‚® Clear key ï‚® Asterisk (*) key ï‚® Ready for input of main
code of simulation.
2) Entering a main code with the 10-key ï‚® START key ON.
Or select a main code with the SIM key on the touch panel.
3) Entering a sub code with the 10-key ï‚® START key ON.
4) Select an item with the scroll key and the item key.
5) The machine enters the mode corresponding to the selected
item. Press [START] key or [EXECUTE] key to start the simu-
lation operation.
To cancel the current simulation mode and change the main
code and the sub code, press [SYSTEM SETTING] key.
Canceling the simulation mode to return to the normal mode
1) Press [CA] key.
CAUTION: Do not turn OFF the power when the machine is in the
simulation mode.
If the power switch should be turned OFF in the simula-
tion mode, a malfunction may be result. In this case,
turn OFF/ON the main power source.
To Next Page
Loading...
Need help?
General
