SICK GM35 User Manual

11
8009389/YN39/V3-0/2015-08| SICK OPERATING INSTRUCTIONS|GM35
Subject to change without notice
PRODUCT OVERVIEW
2Product Overview
2.1 Use and proper application
The GM35 in-situ gas analyzer continuously measures the concentration of CO
2,
H
2
O and
CO or N
2
O, and in gas ducts – as single or simultaneous measurement depending on the
device variant. As in-situ measuring system, the GM35 determines the measured values
directly in the gas-carrying duct without extracting any samples.
• Emission monitoring
The GM35 determines and quantifies pollutants and reference values in gases reliably,
quickly and precisely.
• Process analysis and control
The reliability, precision, and short response time of the GM35 are decisive advantages in
the efficiency of control circuits in all processing creating CO, N
2
O- and CO
2
. Incinerating
and drying plants are reliably monitored and efficiently controlled.
2.1.1 Conformities and certifications
Many areas of application require conformity with certain specifications. The Gas Analyzer
with Measuring Probe GM35 complies with the following requirements:
• Guidelines regarding qualification tests for measuring equipment intended for
continuous emission measurements
• Performance testing of ±2% precision of the measuring range end value (TÜV certified)
• Conformity according to EN 14181 and suitability for emission measurement in plants
according to the 13
th
, 17
th
BImSchV and the TI Air, KAITEC certified (Korea) for
components CO, CO
2
and H
2
O (Cross-Duct and GMP measuring probe versions)
• Conformity with the GOST regulation, Certificate No. DE.C.31.001.A No. 11933
• Conformity with the U.S. EPA regulation CFR 40, Parts 60, 75 and 29 CFR 1310
• KAITEC certified (Korea)
• EMV conformity in accordance with EN 50081-1/EN 50082-2
• CE conformity in accordance with EC Directive EMC 89/336/EWG
• The manufacturer SICK is certified according to ISO 9001
• EC Directive LVD 2006/95/EC
• EU Directive EMC 2004/108/EC
• Applied EN standards:
• EN 61010-1, Safety requirements for electrical equipment for measurement, control and
laboratory use
• EN 61326, Electrical equipment for measurement, control and laboratory use - EMC
requirements

SICK GM35 Specifications

General

Brand	SICK
Model	GM35
Category	Measuring Instruments
Language	English