SICK GM35

50
8009389/YN39/V3-0/2015-08| SICKOPERATING INSTRUCTIONS|GM35
Subject to change without notice
HANDLING THE EVALUATION UNIT
5.2.3.2 Menu structure Diagnosis
Menu Diagnosis
5.2.3.3 Menu structure Calibration
Fig. 24: Menu Calibration
Diagnosis
Plain-text messages,
see page 121.
Plain-text messages,
see page 124.
Current monitoring values of the
sensors (amplifier settings,
internal temperature controls,
etc.)
Cross-Duct version:
● Sender/receiver unit (OH)
Reflector
Check values
Displays the optical alignment of
the SR-unit and reflector in
Measuring mode.
Malfunction
Warning
Sensor Values
Check Values
GM 35 general
CO / N2O
H2O
Probe
CO / N2O
CO2
H2O
Adjust Probe
Cross Duct OH
Cross Duct Refl
Calibration
Check cycle for test purposes,
for example, after maintenance
work
Zero adjust with ambient air,
e.g., during start-up
Filter box measurement for
- control filter (H2O channel,
CO2 for high concentrations).
– test gas (CO, N2O, up to
15 Vol% CO2).
Manual test (CO, N2O, CO2,
H2O),
e.g. with zero gas
Adjustment of device-internal
pressure and temperature
measurement to reference
measurements
¨ back¨ back
Nullabgleich
Nullabgleich
Enter
cal
Check Cycle
Check cycle
Start Check cycle
Procedure successful
Zero Adjust
Zero Adjust CO
Box Measuring
Manual Test
Box Measuring
Manual Test ZERO
Zero gas
CO, CO2
Zero gasCO:
3 ppm
CO2: 0.9 % Vol
H2O: 0.4 % Vol
Start Meas. Grid
Start Meas. Gas