9
8009389/YN39/V3-0/2015-08| SICK OPERATING INSTRUCTIONS|GM35
Subject to change without notice
SAFETY INFORMATION
1 Safety Information
The following information and guidelines apply to the Gas Analyzer with Measuring Probe
GM35 described in this “Operating Instructions” document, and are valid for all user
groups performing any work on or using the analyzer.
1.1 Permissible users
All planning, assembly, installation, start-up, maintenance and repair work must be carried
out by adequately instructed personnel only and checked by skilled persons.
Persons responsible for safety must ensure the following:
• All safety-relevant work is carried out by qualified personnel only.
• Qualified persons are those who, based on their training, experience or instruction as
well as their knowledge of relevant standards, regulations, accident prevention rules and
plant conditions, are authorized by those responsible for safety for personnel and the
plant to carry out such work. It is decisive that these persons can recognize and avoid
possible hazards in a timely manner. Skilled persons are persons according to
DIN VDE 0105 or IEC 364 or directly comparable standards such as DIN 0832.
• These persons have access to the documentation supplied with the system as well as the
relevant technical documentation for all work carried out, and these persons adhere to
the information in this documentation in order to prevent danger or damage.
1.2 Correct handling
To ensure safety precautions are observed and the device is used for its intended purpose,
it is important that:
• The system be used in accordance with the technical data and specifications regarding
permissible usage, assembly, connection, ambient, and operating conditions. These
conditions are governed by the order documents, user information (type plates etc.), as
well as the documentation supplied with the system, which includes these
Operating Instructions.
• Users act in accordance with local, system-specific conditions and with due
consideration paid to operational hazards and specifications.
• All measures necessary for conservation of value are observed, e.g. during transport and
storage and/or maintenance and inspection.
1.3 Safety
Basic measures to prevent property damage and injury to persons
Improper usage or improper handling of Gas Analyzer GM35 can damage health or
material.
WARNING: Risk through incorrect use
Equipment-internal protection devices can be impaired when the device is not
used as defined.
▸ Read the Manual before installation, start-up, operation and
maintenance and observe all information on using the equipment.
NOTICE: Responsibility for the safety of a system
The safety of the system in which the equipment is integrated is the
responsibility of the person setting up the system.
To Next Page
Loading...
Need help?
General
