8 CONFIGURING THE CONNECTION SETTINGS
8027311 / V1-0/2022-04|SICK
OPERATING INSTRUCTIONS|TDC-E (Telematic Data Collector)
Subject to change without notice
Results – before data was sent (update every 2 seconds)
[
{
"Id":"Yellow",
"State":"Off"
},
{
"Id":"Red",
"State":"Off"
}
]
Results – after data was sent (update every 2 seconds)
[
{
"Id":"Yellow",
"State":"On"
},
{
"Id":"Red",
"State":"On"
}
]
8.2.7 Position sensor
• The position sensor (magnetometer) continuously detects coordinates and quantities
for the X-, Y-, and Z-axes (values in milligauss [mG]).
• The sensor has to be activated.
• The sensor data can be retrieved and analyzed using Node-RED or a customer
application.
▸
Open the Magnetometer connection parameter via the gear icon.
▸
Activate the position sensor via the Enabled checkbox.
Configuration
To Next Page
Loading...
