Operating Instructions M90 Fusion Splicer
Issue 02/97 Index
Program selection and adapting
the parameters.............................................5-4
Pull the Working Light out of the Socket............6-2
Putting the Splicer into Operation......................2-3
R
Removing the Battery Retaining Angle..............8-5
Removing the Electrodes................................7-29
Removing the Index-Matching Fluid ................7-27
Removing the Splice.......................................4-24
Resetting the parameters..................................3-2
RS 232 interface...............................................1-9
S
Scope of Delivery..............................................1-2
Selecting the fiber guide....................................2-7
Selecting the Fusion Program ...........................4-3
Selecting the Splicing Sequence ................4-4, 4-5
Semi-automatic.................................................4-4
Service data......................................................3-9
Service support..........................................3-9, 7-5
Setting the default parameters ..........................5-4
Setting the language.........................................3-3
Setting the required attenuation ........................5-4
Significance of the additional parameters ..........5-6
Spares and consumable materials ....................8-3
Splice appearance ..........................................7-10
Splice assessment with video programs..........4-21
Splice loss indication with LID .........................4-21
Splice Memory................................................4-23
Splice organization............................................8-3
Splice protection ...............................................5-5
Splicer shutdown...............................................1-3
Splicing single-mode fibers of type
"Depressed Inner Cladding" .......................7-10
Splicing Unit......................................................1-6
Starting the splicing procedure..........................5-4
Storage Container for Fiber Guides...................2-7
Stow the AC Power Cord in the Case Lid..........6-2
Stow the Tool Set in the Case Lid .....................6-2
Stow the Working Light in the Case Lid.............6-2
Stripping ...........................................................2-9
Stripping length.................................................2-9
Switching Off the Splicer...................................6-2
Switching on the splicer, self-test ......................2-5
T
Technical Specifications....................................5-9
Tensile force...................................................4-22
Tensile test.....................................................4-22
Tool Bag.........................................................1-11
Tools.................................................................6-3
Tools for Electrodes ........................................1-12
Tools for Fiber Guide/Optical System..............1-12
Tools for LID System.......................................1-12
Topping Up the Index-Matching Fluid ..............7-28
Transport Position without Lid ...........................6-5
Troubleshooting ................................................7-2
U
Universal Splice Tray Holder .............................8-9
V
Variable Fusion Curve / Automatic ..................4-15
Variable Fusion Curve / Fully Automatic..........4-14
Variable Fusion Curve / Manual.......................4-17
Variable Fusion Curve / Semi-Automatic .........4-16
Venting Hole ..............................................2-5, 8-4
Visual assessment ..........................................4-21
W
Working light ..............................................2-4, 6-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...