© 2008 Siemens Energy & Automation, Inc. All Rights Reserved
ACCESS 9340 and 9360 Meters PMCM-9340D-0208
Appendix B—Using the Command Interface 2/2008
EN–208
Setup
9020 None None Enter into setup mode.
9021 8001
1 = Save
2 = Do not save
Exit setup mode and save all changes.
Table B–2: Command Codes
Command
Code
Command
Parameter
Register
Parameters Description
➀You must write to register 8001 the number that identifies which output you would like to use.
To determine the identifying number, refer to“I/O Point Numbers” on page 209 for instructions.
➁Data buffer location (register 8019) is the pointer to the first register where data will be stored. By default,
return data begins at register 8020, although you can use any of the registers from 8020–8149. Take care when
assigning pointers. Values may be corrupted if two commands are using the same register.
To Next Page
Loading...
