Siemens SENTRON ATC6300 - Page 118

Parameterization
9.1 Parameterization via the user interface
3KC ATC6300 transfer control device
116 Manual, 03/2018, L1V30535632002A-01
The following submenus are available in the setup menu:
Code
Designation
Description
P01
SETTINGS
Language, brightness, display pages etc.
P02 GENERAL Key system data
P03
PASSWORD
Setting of the access code
P04
BATTERY
Battery parameters
P05
CHANGEOVER
Basic settings regarding load changeover
P06
PARAMET. LINE1
Limit thresholds relating to Line I
P07
PARAMET. LINE2
Limit thresholds relating to Line II
P08
COMMUNICATION
Communication parameters
P09
AUTOMAT. TEST
Period, duration, mode of automatic test
P10
DIGIT. INPUTS
Programmable functions of the digital inputs
P11
DIGIT. OUTPUTS
Programmable functions of the digital outputs
P12
MISCELLANEOUS
Functions such as maintenance etc.
P13
LIMITS
Programmable limit thresholds
P14
COUNTERS
Programmable generic counters
P15
USER ALARMS
Programmable alarms
P16
ALARM TABLE
Alarms effect enabling
The submenus list all parameters with their code, description and actual setting
The example below shows the P04 Battery submenu:
①
Present setting value
②
Currently selected parameter
③
Parameter description
④
Parameter code
To change the value of a parameter, select it and press ✓.
Note
Access denial
If the password has been enabled for the advanced level, access to this editing page is not
possible and the access denied message is displayed.