Siemens SENTRON ATC6300 - Designation and Description of Outputs

Operation
8.3 Designation and description of the outputs
3KC ATC6300 transfer control device
110 Manual, 03/2018, L1V30535632002A-01
Function
Description
Key AUT simulation Closing the input is the equivalent of pressing the
AUT key. The operating mode is changed ac-
cordingly.
Automatic test inhibition Inhibits the automation test.
LED test
Makes all the LEDs on the front panel flash.
Close Breaker 1 (BRK 1) In the manual mode this function closes the
Breaker 1.
Open Breaker 1 (BRK 1) In the manual mode this function opens the
Breaker 1.
Toggle Breaker 1 (BRK 1) In the manual mode this function toggles the
status of Breaker 1.
Close Breaker 2 (BRK 2) In the manual mode this function closes the
Breaker 2.
Open Breaker 2 (BRK 2) In the manual mode this function opens the
Breaker 2.
Toggle Breaker 2 (BRK 2) In the manual mode this function toggles the
status of Breaker 2.
Auxiliary voltage ready
If this NC contact is open, alarm A18 is triggered.
Revision If enabled, this function causes the following
reactions during revision of the system:
• switch to OFF mode
• disabling of feedback alarms A03-A04
• enabling of any undervoltage release
8.3
Designation and description of the outputs
8.3.1
Digital outputs OUTx
The ATC6300 has 7 permanently integrated digital outputs which are designated as OUTx.
Designation
Description
Mounted on the device
Maximum number with
expansion modules
OUTx
Digital output
1 - 7
8 - 15
The function of the integrated digital outputs can be freely parameterized by the user: