Siemens SENTRON ATC6300 - Technical Specifications

Accessories
12.1 Expansion modules
3KC ATC6300 transfer control device
Manual, 03/2018, L1V30535632002A-01
181
12.1.2.1
Technical specifications
Power supply
Supply voltage
5 V DC (supplied through the ATC6300)
Current consumption (max.) 20 mA
Power loss (max.)
0.1 W
SSR output
Output type
Solid state relays (Opto-Mosfet)
Solid state output rating (at 60°C)
Max. 55 mA at 40 V DC / 30 V AC
Contact type
4 NO contacts
Connecting terminals
Removable / plug-in
Cable cross-section (min-max)
0.2 … 1.5 mm
2
(AWG 28 ... 14)
Tightening torque
0.18 Nm (1.7 lbf-in)
Insulation
Impulse withstand voltage U
imp
7.3 kV
Operating frequency impulse withstand voltage
4 kV
Ambient conditions
Operating temperature
-20 … +60 °C
Storage temperature
-30 … +80 °C
Relative humidity
< 80 % (IEC / EN 60068-2-70)
Maximum degree of pollution
2
Overvoltage category
3
Altitude of environment (max.)
≤ 2000 m
Enclosure
Enclosure material
Polyamide RAL7035
Degree of protection
IP20
Weight
54 g
Certifications and approvals
The following standards are complied with:
cULus
Complies with standards IEC / EN 61010-1
IEC / EN 61000-6-2
IEC / EN 61000-6-3
UL 508
CSA C22.2-N°14
UL marking Four solid state outputs:
• 30 V AC, 55 mA general use
• 40 V AC, 55 mA general use
Use 60° C / 75 °C copper (CU) conductor only
AWG Range: 28 - 14 AWG stranded or solid
Field wiring terminals tightening torque:
1.7 lbf-in