3KC ATC6300 transfer control device
Manual, 03/2018, L1V30535632002A-01
63
The following chapter contains information on:
● Dimensions for the door cutout
● Installation of the ATC6300
Additional information can be found in the Operating instructions for 3KC ATC6300 transfer
control device (https://support.industry.siemens.com/cs/ww/en/view/109751946
).
Dimensions for the door cutout
The ATC6300 is intended for door mounting.
When correctly installed and with simultaneous use of the cover frame 3KC9000-8TL67,
IP65 protection is achieved at the front.
The door cutout for the ATC6300 must have the following dimensions:
Installation of the ATC6300
The ATC6300 is attached to the door using the clips included in the scope of delivery.
To Next Page
Loading...
