Parameterization
9.2 Parameterization via the powerconfig software
3KC ATC6300 transfer control device
Manual, 03/2018, L1V30535632002A-01
119
Parameterization via the front interface
9.2.2.1
Attaching the front interface
1. Secure the adapter for the front interface in the ATC6300.
2. Connect the supplied USB connecting cable (length 1.5 m) to the adapter and to your PC.
3. Launch the powerconfig software.
4. Parameterize the device.
Further information on the subject of powerconfig
(https://support.industry.siemens.com/cs/ww/en/ps/19790
) can be found on the Internet.
By means of the USB front interface, the device can be parameterized without the need for a
cutout in the cabinet door (3KC9000-8TL73).
This is electrically isolated from the circuits of the ATC6300.
Note
Software required
In order to parameterize the device using the USB front interface you require the
powercon
fig software, version 3.10 or higher.
To Next Page
Loading...
