Siemens SENTRON ATC6300 - Technical Specifications

Accessories
12.1 Expansion modules
3KC ATC6300 transfer control device
184 Manual, 03/2018, L1V30535632002A-01
12.1.3.1
Technical specifications
Power supply
Supply voltage
5 V DC (supplied through the ATC6300)
Current consumption (max.) 250 mA
Power loss (max.)
1.25 W
Digital inputs
Number of digital inputs
2
Input type
Positive or negative
Input current
7 mA
Input signal - logical state "0"
Must be an open collector signal
Input signal - logical state "1" ≥ 17.6 V (for PNP type)
≤ 6.4 V (for NPN type)
Maximum frequency 2000 Hz (if the input is configured as a counter)
50 Hz (if input is configured as status)
Input signal delay
≥ 50 ms
Auxiliary supply terminals + and - terminal
Auxiliary power supply at + and - 24 V DC (see tolerance graph in chapter Expansion module 2DI
2DO (Page 182))
Maximum current at + and - 42 mA (protected against overload and short-circuit)
Note
: If the maximum current is exceeded, the protection is ena-
bled and the voltage drops
Number of terminals
2
SSR output
Output type
Solid state relays (Opto-Mosfet)
Solid state output rating (at
60 °C)
Max. 55 mA at 40 V DC / 30 V AC
Connection
Connecting terminals
Removable / plug-in
Cable cross-section (min-max)
0.2 … 1.5 mm
2
(AWG 28 ... 14)
Tightening torque
0.18 Nm (1.7 lbf-in)
Insulation
Impulse withstand voltage Uimp
4 kV
Operating frequency impulse
withstand voltage
2 kV
Ambient conditions
Operating temperature
-20 … +60 °C
Storage temperature
-30 … +80 °C
Relative humidity
< 80 % (IEC / EN 60068-2-70)
Maximum degree of pollution
2
Overvoltage category
3
Altitude of environment (max.) ≤ 2000 m