Siemens SENTRON ATC6300 - Page 23

Product description
4.1 Product description
3KC ATC6300 transfer control device
Manual, 03/2018, L1V30535632002A-01
21
Keys
No.
Key
Function
③
Key ▲
• Pressing this key switches between menu pages. Within the menus, it is used to switch between
the parameters.
④
MAN
/
+
• Pressing the
MAN / +
key for at least 0.5 seconds selects the Manual operating mode.
• If the
MAN / +
key is pressed within the individual menus, the parameters can be increased.
⑦
Key ▼
• Pressing this key switches between menu pages. Within the menus, it is used to switch between
the parameters.
⑧
AUT
/
✓
• Pressing the
AUT / ✓
key for more than 0.5 seconds selects the automatic mode.
• Pressing the
AUT / ✓
key also confirms any settings that have been made.
⑪
OFF
/
-
• Pressing the
OFF / -
key for more than 0.5 seconds selects the OFF mode.
• If the
OFF / -
key is pressed within the individual menus, the parameters can be reduced.
Simultaneously pressing the
▲
and
▼
keys returns you to the main menu. You can find more
information in chapter
Menu navigation (Page 22).
Interface
A 3KC9000-8TL73 USB front interface can be attached to interface 5. This enables the
ATC6300 transfer control device to be parameterized from the front using powerconfig
(Version 3.10 or higher).
Further information on the 3KC9000-8TL73 USB front interface can be found in chapter
Parameterization via the front interface (Page 119) or in chapter USB front interface -
3KC9000-8TL73 (Page 194)
QR code
The QR code 6 contains information that refers to the Industry Mall page of the ATC6300
transfer control device, where further information is available, e.g. operating instructions and
certificates.