Siemens SIMATIC ET 200iSP

② Cyclic data exchange:
• Con󹪝guration
• Parameters
• Read identi󹪝cation and maintenance data
• Diagnostic interrupts
③ Acyclic data exchange:
• Parameters
• Read and write identi󹪝cation and maintenance data
• HART access
Figure 7-1 Principle of project engineering
Con󹪝guring
Con󹪝guration is the con󹪝guration and parameter assignment of the ET 200iSP with the PG.
Con󹪝guring
• Con󹪝guration with PROFINET connection
During con󹪝guration you set the properties of the IO device (e.g. network parameters,
module selection in HW Con󹪝g). You con󹪝gure the ET 200iSP with
– Engineering tool (e.g. STEP 7; PCS 7)
• Con󹪝guration with PROFIBUS connection
Only set the basic properties of the DP device during con󹪝guration (e.g. network parameters,
module selection in HW Con󹪝g). You con󹪝gure the ET 200iSP with
– Engineering tool (e.g. STEP 7; PCS 7)
– COM PROFIBUS or with a suitable engineering tool (via the GSD 󹪝le).
Note
Slots as reserve for changes during operation (CiR)
If you want to make changes during operation, you must observe the following:
Adjacent slots are not permitted as spare slots if the spare slots are followed by con󹪝gured
electronic modules.
Commissioning and Diagnostics
7.1 Basics of commissioning and diagnostics
ET 200iSP
156 Operating Instructions, 11/2022, A5E00247483-AK