6. Save the changes (menu command File > Save) to update the le.
7. Load all parameters into the modules (menu command Device > Full download to device).
Exit SIMATIC PDM.
Reference
You can nd additional information on the parameter assignment in the documentation and
online help of SIMATIC PDM.
7.5 Assigning Parameters for the ET 200iSP during Operation using
SIMATIC PDM
Properties
• You can congure the modules during operation using SIMATIC PDM. Each new parameter
assignment that is correct is applied by the module and retentively stored.
• Incorrect parameters are ignored. The module remains in the previous conguration state.
• Restarting the modules (after supply voltage of the ET 200iSP o ---> on) results in the
currently retentively stored conguration being applied in the modules: LED "SF" of the
electronic modules o
• Applying the retentively stored conguration in the modules is independent of the
communication of the ET 200iSP to the higher-level component (IO controller/DP master).
• The outputs of the modules are controlled by the higher-level components (IO controller/
Class 1 DP master).
Requirements
• PROFINET: SIMATIC PDM as of V9.2.2 (integrated or "stand alone" version)
• PROFIBUS: SIMATIC PDM as of V6.0 (integrated or "stand alone" version)
Procedure for re-conguration
1. Start SIMATIC PDM.
2. Open the project.
3. Switch the view in the SIMATIC Manager: Menu command View > Process Network View.
4. Select the desired ET 200iSP module in the left part of the window. Select "Open objects" in
the shortcut menu. Result: SIMATIC PDM starts.
5. Load the parameters and/or I&M of the module into the PG/PC.
6. Change the parameters and/or I&M.
Commissioning and Diagnostics
7.5 Assigning Parameters for the ET 200iSP during Operation using SIMATIC PDM
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK 165
To Next Page
Loading...
Need help?
General
