Siemens SIMATIC ET 200iSP - Preface

Preface
Purpose of the documentation
This documentation provides the information you need to plan, install, wire and commission the
product " ET 200iSP distributed I/O device" in automation systems.
Con󹪝guration variants of the ET 200iSP sta‐
tion
Requirements
Station on the PROFINET IO Connection of the PROFINET IO device via 󹪝ber-optic cable
Station on the PROFIBUS RS 485‑IS Connection of the PROFIBUS DP device via RS 485‑IS coupler
Guide
This documentation describes the hardware of the ET 200iSP distributed I/O device. It consists
of instructional sections and sections for reference (technical speci󹪝cations):
• Installing and wiring the distributed I/O device
• Commissioning and diagnostics of the distributed I/O device
• Components of the distributed I/O device
• Article numbers
Basic knowledge required
General knowledge in the 󹪝eld of automation technology and quali󹪝cations are required to
understand the documentation:
Activities Quali󹪝cations
Installing the
ET 200iSP
• Basic technical training
• Knowledge of safety regulations regarding the workplace
Wiring of the
ET 200iSP
• Basic practical training in electro-engineering
• Knowledge of the relevant electrotechnical safety regulations
• Knowledge of methods of installing explosion-proof electrical equipment
• Knowledge of safety regulations regarding the workplace
Commissioning
of the ET 200iSP
• Knowledge of all electrical and functional parameters and properties of the ET 200iSP
• Knowledge of the function and commissioning of the network connection (PROFINET IO/PROFIBUS DP)
• Knowledge of the connected encoders, actuators, and HART 󹪝eld devices
• Knowledge of the safety regulations regarding the workplace, particularly regarding procedures in
hazardous areas
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK 3