Siemens SIMATIC ET 200iSP

Principle
The following 󹪝gure graphically illustrates the principle of chatter monitoring.
1BSBNFUFSGPSOVNCFSPGTJHOBMDIBOHFT
1SPDFTTTJHOBM
%JBHOPTUJDT
%JBHOPTUJDT꫽VUUFSFSSPS
JODPNJOH
3FQPSUJOH
.PEVMFEJBHOPTUJDT'MVUUFS
FSSPSPVUHPJOH
3FTFUUJOH
%FUFDU
.POJUPSJOHXJOEPXY
1BSBNFUFSTGPSNPOJUPSJOH
XJOEPX
U
UYUY
Figure 13-11 The principle of chatter monitoring
13.6.4 Shutdown signal
Parameter description: Shutdown signal
The parameter Shutdown signal can only be set for the shut down "L" output modules.
Enable shutdown signal: You have connected a shutdown signal.
Shutdown signal disabled: You have no shutdown signal connected.
13.6.5 Parameters for counting
Description
See section "Counting (Page 91)"
Digital electronic modules
13.6 Description of the parameters of the digital electronic modules
ET 200iSP
342 Operating Instructions, 11/2022, A5E00247483-AK