Siemens SIMATIC ET 200iSP User Manual

Installing the component
1. Install the mounting rail (160 mm) on a stable base.
2. Place the component from below onto the DIN rail and turn it into place.
Note
Install the component in Zone 2 or in a safe area. Use an enclosure.
3.6 Wiring the example con󹪝guration for PROFINET
Wiring of the TM-PS-A
-
.
1"
Figure 3-2 Wiring TM-PS-A
Requirements for example con󹪝guration with PROFINET IO/󹪝ber-optic cable
• PROFINET IO cable with RJ45 or FastConnect plug at both ends
• Fiber-optic cable with LC plug at both ends
Observe the following information:
– Optical connection in and through ATEX/IECEx Zone 1 or 21 (
https://
support.industry.siemens.com/cs/ww/en/view/109761426)
Wiring the example con󹪝guration
1. Connect the engineering tool (PG) and the PROFINET IO interface of the CPU using your own
cable.
2. Connect the DIN rails of the CPU with the protective conductor.
3. Connect the mounting rail of the ET 200iSP and the power supply PS with the equipotential
bonding PE. Use the grounding bolt for fastening to the DIN rail.
Commissioning guideline
3.6 Wiring the example con󹪝guration for PROFINET
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK 43

Siemens SIMATIC ET 200iSP Specifications

General

Brand	Siemens
Model	SIMATIC ET 200iSP
Category	I/O Systems
Language	English