Siemens SIMATIC ET 200iSP User Manual

Function DPV0
de‐
vice
S7 DP
device
DPV1
device
Comment
• Time stamping
--- X X
1
If you con󹪝gure the ET 200iSP with the GSD 󹪝le (in HW Con󹪝g), then you need SIMATIC PDM for the
parameter assignment.
2
With the S7 DP device, diagnostic and hardware interrupts are only signaled when the CPU is in RUN
mode.
DPV0
"DPV0" mode designates a mode for communication between devices on the PROFIBUS.
The mode includes the basic functions of the PROFIBUS DP communication protocol
• Cyclic data exchange between control system and devices
• Con󹪝guration via GSD 󹪝les
• Diagnostics
DPV1
"DPV1" mode is a further development of the original PROFIBUS standard IEC 61784-1:2002 Ed1
CP 3/1.
DPV1 designates a mode for communication between devices on the PROFIBUS.
The mode extends the functions of the PROFIBUS DP communication protocol compared to
"DPV0" mode. The changes are speci󹪝ed in the IEC 61158 standard:
• Acyclic data exchange between control system and devices
• Integration into engineering systems via EDD or FDT / DTM
• Transferable PLC software function blocks (IEC 61131‑3)
• Fail‑safe communication (PROFIsafe)
• Interrupts (hardware interrupt, status interrupt, update interrupt, vendor-speci󹪝c interrupt,
diagnostic interrupt, plug interrupt, pull interrupt)
7.3 Project engineering with STEP 7
Properties
• The ET 200iSP is included in the STEP 7 hardware catalog.
• Diagnostic interrupts, hardware interrupts, pull/plug interrupts (only for S7-400) and time
stamping are supported.
Commissioning and Diagnostics
7.3 Project engineering with STEP 7
ET 200iSP
160 Operating Instructions, 11/2022, A5E00247483-AK

Siemens SIMATIC ET 200iSP Specifications

General

Brand	Siemens
Model	SIMATIC ET 200iSP
Category	I/O Systems
Language	English