Siemens SIMATIC ET 200iSP User Manual

4.10 Identi󹪝cation and maintenance data I&M
Properties
Identi󹪝cation data (I data): Information about the module that is normally printed on the
enclosure of the module. I data is read-only.
Maintenance data (M data): System-speci󹪝c information such as the installation location and
date. M data is generated during con󹪝guration and written to the module.
Identi󹪝cation and maintenance data (I&M) is information stored in a module that supports you
in
• Troubleshooting in a system
• Checking the system con󹪝guration
• Locating hardware changes in a system
Reading and writing the identi󹪝cation and maintenance data with STEP 7
• PROFINET connection via IM 152-1PN:
In HW Con󹪝g, the I&M are displayed in the "Module status - IM 152-1PN" and "Properties -
IM-152-1PN" tabs.
• PROFIBUS connection via IM 152-1DP:
In HW Con󹪝g, the I&M are displayed in the "Module status - IM 152-1DP" and "Properties - DP
Slave" tabs.
For additional information on this: See STEP 7 online help.
Reading and writing of the I&M with SIMATIC PDM
With SIMATIC PDM you can read the parameters and I&M e.g. via the menu command File > Full
upload to PG/PC and write via the menu command Device > Full download to device .
Con󹪝gurations (principle)
4.10 Identi󹪝cation and maintenance data I&M
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK 77

Siemens SIMATIC ET 200iSP Specifications

General

Brand	Siemens
Model	SIMATIC ET 200iSP
Category	I/O Systems
Language	English