Siemens SIMATIC ET 200SP System Manual

Wiring
6.9 Wiring BaseUnits for motor starters
Distributed I/O system
108 System Manual, 09/2019, A5E03576849-AJ
Releasing conductors
To release a conductor, proceed as follows:
1. Press the screwdriver into the spring release of the terminal until it engages.
2. Pull the conductor out.
Note
When pressing the spring release, you must not pull on the wire/cable at the same time. In
this way, you avoid damaging the terminal.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C