Siemens SIMATIC ET 200SP System Manual

Technical specifications
14.4 Shipping and storage conditions
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
281
14.4 Shipping and storage conditions
Introduction
The ET 200SP distributed I/O system exceeds requirements in terms of shipping and
storage conditions according to IEC 61131-2. The following information applies to modules
that are shipped and/or stored in their original packaging.
Table 14- 7 Shipping and storage conditions for modules
Type of condition
Permissible range
Free fall (in shipping package)
≤1 m
Temperature
From -40 °C to +70 °C
Barometric pressure from 1140 to 660 hPa (corresponds to an elevation
of -1000 to 3500 m)
Relative humidity 5% to 95%, without condensation
Sinusoidal oscillations according to
IEC 60068-2-6
5 - 8.4 Hz: 3.5 mm
8.4 - 500 Hz: 9.8 m/s
2
Impact acc. to IEC 60068-2-27
1)
250 m/s
2
, 6 ms, 1000 shocks
1) Not applicable to motor starters

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C