Siemens SIMATIC ET 200SP System Manual

Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
3
Preface
Preface
Purpose of the documentation
This documentation provides important information on configuring, installing, wiring and
commissioning the ET 200SP distributed I/O system.
Basic knowledge required
A basic knowledge of automation technology is required to understand the documentation.
Validity of the documentation
This documentation applies to the distributed I/O system, ET 200SP.
Definition
In this document, " motor starter" always refers to all variants of the ET 200SP motor
starters.
Conventions
Please pay particular attention to notes highlighted as follows:
Note
Notes contain important information on the product, handling the product or on part of the
documentation to which you should pay particular attention.
Standards
You can find a dated reference to the respective standards or the EC Declaration of
Conformity on the Internet (https://support.industry.siemens.com
)

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C