Siemens SIMATIC ET 200SP - Commissioning the ET 200 SP for PROFINET IO; ET 200 SP CPU as an IO Controller

Commissioning
11.2 Commissioning the ET 200SP for PROFINET IO
Distributed I/O system
194 System Manual, 09/2019, A5E03576849-AJ
11.2 Commissioning the ET 200SP for PROFINET IO
Requirements
● The CPU/interface module is in the "Factory settings" status or has been reset to factory
settings (see section Interface module
(http://support.automation.siemens.com/WW/view/en/55683316/133300
)).
● For CPU: The SIMATIC memory card is as delivered or has been formatted.
11.2.1 ET 200SP CPU as an IO controller
Configuration example
To use the ET 200SP distributed I/O system as an IO controller, you require the
CPU 151xSP-1 PN.
Figure 11-1 ET 200SP CPU as an IO controller