Siemens SIMATIC ET 200SP System Manual

Installation
5.9 Mounting further accessories for motor starters
Distributed I/O system
80 System Manual, 09/2019, A5E03576849-AJ
5.9 Mounting further accessories for motor starters
5.9.1 Mounting the cover for the 500 V AC infeed bus
Introduction
The 500 V infeed bus connects all SIMATIC ET 200SP motor starters. For finger-safe
termination of the infeed bus, you must use the cover.
DANGER
Hazardous Voltage
Can Cause Death, Serious Injury, or Property Damage.
Hazardous electrical voltage causes electric shock, burns and property damage.
Disconnect your system and devices from the power supply before starting any assembly
tasks.
DANGER
Infeed bus - electric shock
You must provide the infeed bus with a touch protection cover on the right (Article No.:
3RK1308-1DA00-2BP0).
Failure to do so will result in the danger of electric shock.
WARNING
Personal injury may occur
On the last plugged-in BaseUnit of a motor starter, place a cover on the opening of the
contacts of the infeed bus.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C