Siemens SIMATIC ET 200SP System Manual

Distributed I/O system
267 System Manual, 09/2019, A5E03576849-AJ
Technical specifications
14
Introduction
This chapter lists the technical specifications of the system:
● The standards and test values that the ET 200SP distributed I/O system complies with
and fulfills.
● The test criteria according to which the ET 200SP distributed I/O system was tested.
Technical specifications for the modules
The technical specifications of the individual modules can be found in the manuals of the
modules themselves. In the event of deviations between the statements in this document
and the manuals, the statements in the manuals take priority.
14.1 Standards, approvals and safety notes
Currently valid markings and approvals
Note
Information on the components of the ET 200SP
The currently valid markings and approvals are printed on the components of the ET
200SP
distributed I/O system.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C