Siemens SIMATIC ET 200SP - Configuring the Interface Module

Configuring
7.3 Configuring the interface module
Distributed I/O system
142 System Manual, 09/2019, A5E03576849-AJ
7.3 Configuring the interface module
Configuring
Read the STEP 7 online help and/or the documentation of the configuration software
manufacturer when configuring the interface module.
The F-destination address is saved permanently on the coding element of the ET 200SP fail-
safe modules. Fail-safe motor starters do not need an F-destination address or a coding
element.
Note
The supply voltage
L+ must be applied to the F-module when the F-destination address is
assigned.
Note
Note the following in conjunction with configuration control:
Before you can use configuration control together with F
-modules, you must assign the
F
-destination address to the F-modules at the designated slots. For this, each F-module
must be inserted in the slot configured for it. The actual configuration can then differ from the
specified configuration.
For additional information on assigning the F-destination address, refer to the SIMATIC
Safety - Configuring and Programming
(http://support.automation.siemens.com/WW/view/en/54110126
) Programming and
Operating Manual and to the online help for the S7 Configuration Pack .