Siemens SIMATIC ET 200SP - Startup of the ET 200 SP with Empty Slots

Commissioning
11.4 Startup of the ET 200SP with empty slots
Distributed I/O system
204 System Manual, 09/2019, A5E03576849-AJ
Step
Procedure
See ...
9 Checking LEDs Interface module
(http://support.automation.siemens.com/
WW/view/en/55683316/133300) Manual
10 Testing inputs and outputs The following functions are helpful: Mon-
itoring and modifying tags, testing with
program status, forcing, controlling the
outputs. Refer to section Test and ser-
vice functions (Page 258)
11.4 Startup of the ET 200SP with empty slots
Procedure
You can configure the ET 200SP distributed I/O system with any number of empty slots.
To build the ET 200SP distributed I/O system with any number of empty slots, follow these
steps:
1. Cover all empty slots with BU covers.
2. Finish the configuration with a server module.
Special consideration: A "Module missing in slot x" diagnostic message is generated by the
CPU/interface module for empty slots in which I/O modules are configured.