Siemens SIMATIC ET 200SP - Use of the ET 200 SP in Zone 2 Potentially Explosive Atmospheres

Technical specifications
14.7 Use of the ET 200SP in zone 2 potentially explosive atmospheres
Distributed I/O system
288 System Manual, 09/2019, A5E03576849-AJ
14.7 Use of the ET 200SP in zone 2 potentially explosive atmospheres
See product information "Use of subassemblies/modules in Zone 2 Hazardous Area"
(http://support.automation.siemens.com/WW/view/en/19692172
).
Note
Zone 22: Observe standards and regulations, and individual acceptance test required
If you install, use and mainta
in the ET 200SP in hazardous area Zone 22, you must comply
with the relevant standards, installation/setup regulations and country
-
specific regulations for
Zone 22 (for example, the ET 200SP must be installed in an enclosure
suitable for Zone 22).
A indivi
dual acceptance test by a certification body (Ex) is also required.