Siemens SIMATIC ET 200SP System Manual

Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
7
Table of contents
Preface ...................................................................................................................................................... 3
1 ET 200SP Documentation Guide ............................................................................................................. 12
2 New properties/functions ......................................................................................................................... 14
3 System overview ...................................................................................................................................... 16
3.1 What is the SIMATIC ET 200SP distributed I/O system? ....................................................... 16
3.2 What are fail-safe automation systems and fail-safe modules? ............................................. 19
3.3 How are SIMATIC Safety F-systems structured with ET 200SP? .......................................... 20
3.4 Components ............................................................................................................................ 24
4 Application planning ................................................................................................................................. 33
4.1 Selecting the BaseUnit for I/O modules .................................................................................. 38
4.1.1 Digital, fail-safe, communication, technology or analog modules without temperature
measurement .......................................................................................................................... 38
4.1.2 Analog modules with temperature measurement ................................................................... 39
4.2 Selecting motor starters with a suitable BaseUnit .................................................................. 40
4.2.1 Selecting a BaseUnit for motor starters .................................................................................. 40
4.2.2 Selecting the motor starter ...................................................................................................... 42
4.2.3 Selecting accessories for motor starters................................................................................. 43
4.3 Selecting potential distributor modules ................................................................................... 44
4.3.1 Selecting a PotDis-BaseUnit ................................................................................................... 44
4.3.2 Selecting a PotDis-TerminalBlock .......................................................................................... 46
4.4 Hardware configuration ........................................................................................................... 47
4.5 Forming potential groups ........................................................................................................ 49
4.5.1 Basics ..................................................................................................................................... 49
4.5.2 Forming potential groups with BaseUnit type B1 .................................................................... 54
4.5.3 Forming potential groups with fail-safe modules .................................................................... 55
4.5.4 Forming potential groups with motor starters ......................................................................... 57
4.6 Configuration examples for potential groups .......................................................................... 59
4.6.1 Configuration examples with BaseUnits ................................................................................. 59
4.6.2 Configuration examples with potential distributor modules .................................................... 61
5 Installation ............................................................................................................................................... 63
5.1 Basics ..................................................................................................................................... 63
5.2 Installation conditions for motor starters ................................................................................. 67
5.3 Mounting the CPU/interface module ....................................................................................... 69
5.4 Installing the CM DP communication module ......................................................................... 71
5.5 Mounting BaseUnits for I/O modules ...................................................................................... 73
5.6 Mounting and dismantling BaseUnits for motor starters ......................................................... 76

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C