Siemens SIMATIC ET 200SP - Operating Hours Counter

Installation
5.3 Mounting the CPU/interface module
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
69
NOTICE
Ensure interference immunity
You must not plug any other module into the BaseUnit of the dummy module, otherwise
interference immunity is no longer ensured.
5.3 Mounting the CPU/interface module
Introduction
The CPU/the interface module connects the ET 200SP distributed I/O system to the fieldbus
and exchanges the data between the higher-level control system and the I/O modules /
motor starters.
Requirement
The mounting rail is fitted.
Required tools
3 to 3.5 mm screwdriver (only for mounting and removing the BusAdapter)