Commissioning
11.2 Commissioning the ET 200SP for PROFINET IO
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
197
Commissioning procedure
For commissioning of the ET 200SP distributed I/O system as an I-device on the
PROFINET IO, we recommend the following procedure:
Table 11- 2 Procedure for commissioning the ET 200SP as an I-device on the PROFINET IO
Section Installation (Page 63)
2 Connecting ET 200SP
• Supply voltages
• PROFINET IO
• Sensors and actuators
Section Wiring (Page 86)
3 Inserting a SIMATIC memory card in the I-
Section Removing/inserting a SIMATIC
memory card on the CPU (Page 205)
Section Configuring (Page 131)
Checking the protective measures
6 Switching on supply voltages for the IO
Documentation of the IO controller
7 Switching on supply voltages for I-device
and IO devices
CPU 15xxSP-1 PN
(http://support.automation.siemens.com/
WW/view/en/90466439/133300) manual
and documentation of the IO devices
Download configuration to the I-device
9 Switching IO controller and I-device to RUN
mode
Documentation of the IO controller and
CPU 15xxSP-1 PN
(http://support.automation.siemens.com/
WW/view/en/90466439/133300) manual
10 Checking LEDs CPU 15xxSP-1 PN
(http://support.automation.siemens.com/
WW/view/en/90466439/133300) manual
11 Testing inputs and outputs The following functions are helpful: Mon-
itoring and modifying tags, testing with
program status, forcing, controlling the
outputs. See section Test and service
functions (Page 258)
To Next Page
Loading...
Need help?
General
