EasyManuals Logo

Siemens SIMATIC ET 200SP System Manual

Siemens SIMATIC ET 200SP
320 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #255 background imageLoading...
Page #255 background image
Maintenance
12.7 Resetting CPU/interface module (PROFINET) to factory settings
Distributed I/O system
254 System Manual, 09/2019, A5E03576849-AJ
3. Install the interface module back on the mounting rail (see Mounting the CPU/interface
module (Page 69)).
4. Assign parameters to the interface module again.
Rear of the interface module
RESET button
Figure 12-6 RESET button

Table of Contents

Other manuals for Siemens SIMATIC ET 200SP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC ET 200SP and is the answer not in the manual?

Siemens SIMATIC ET 200SP Specifications

General IconGeneral
System TypeDistributed I/O System
MountingDIN Rail
Communication ProtocolPROFINET, PROFIBUS
IP RatingIP20
CategoryI/O Systems
Supply Voltage24 V DC
ModularityYes
Hot SwappingYes
Storage Temperature-40°C to +70°C
Digital InputsYes
Digital OutputsYes
Analog InputsYes
Analog OutputsYes
Communication InterfacePROFINET, PROFIBUS
Number of ModulesUp to 64
Relative Humidity5 to 95% (non-condensing)
Operating Temperature-25°C to +60°C

Related product manuals