Installation
5.3 Mounting a system power supply module
S7-1500 Automation System
46 System Manual, 01/2013, A5E03461182-01
Dismantling a system power supply module
The system power supply is wired up.
1. Turn off the fed supply voltage.
2. Open the front cover.
3. Shut down the system power supply.
4. Disconnect the power cable connector, and remove the connector from the system power
supply.
5. Undo the power supply module's fixing screw(s).
6. Swivel the system power supply out of the mounting rail.
Reference
Further information can be found in the Manuals for the system power supplies.
To Next Page
Loading...
