Wiring
6.9 Marking the I/O modules
S7-1500 Automation System
76 System Manual, 01/2013, A5E03461182-01
6.9 Marking the I/O modules
6.9.1 Labeling strips
Introduction
Mark the pin assignment of the I/O modules using labeling strips. The labeling strip can be
written on as desired, and is slid into the outside of the front cover.
The labeling strips are available in the following models:
● Pre-prepared strips that are included with the I/O module as delivered.
● DIN A4 sheets, pre-perforated strips for machine printing. See the chapter
Accessories/Spare Parts (Page 193).
Preparing and installing the labeling strip
Proceed as follows to prepare and install the labeling strips:
1. Label the labeling strip.
2. With a pre-perforated strip: Separate the labeling strip from the sheet.
3. Slide the labeling strip into the outside of the front cover.
① Labeling strips
Figure 6-17 Marking with labeling strips
To Next Page
Loading...
