General information
2.3 Information on use
Operating with the Local User Interface
18 Operating Manual, 06/2017, A5E31930478-05
If you are using SIPROCESS GA700 devices in critical processes, observe the following
information:
● Monitor the limits externally via the control system.
● Read out the device status only via the digital outputs of the analyzer module.
● Use an available manual measuring range switchover instead of the autoranging.
● Only use the "Total" parameter with the "Off" setting for the measuring range switchover.
● If you use the "Correction of cross-interference" and "External pressure compensation"
functions, store suitable substitute values.
● Only access the measured value via an analog output.
To Next Page
Loading...
