Siemens SIPROCESS GA700 - [2.20] Settings > Service

Functions
6.14 [2.20] Settings > Service
Operating with the Local User Interface
190 Operating Manual, 06/2017, A5E31930478-05
6.14
[2.20] Settings > Service
6.14.1
[2.20.02] Heaters
6.14.1.1
[2.20.02] Heaters OXYMAT 7
Service menu. You only have read access.
The following information is displayed in this menu:
● Indication of the type of installed sample chamber.
● Display of temperature setpoints and actual values from sample chamber and measuring
head.
6.14.1.2
[2.20.02] Heaters ULTRAMAT 7
Service menu. You only have read access.
The following information is displayed in this menu:
● Indication of the type of installed sample chamber.
● Indication of the activation state of the gradient controller. When the gradient controller is
active, the corresponding temperature setpoint and actual temperature value are
displayed.
● Display of the current chopper temperature.
6.14.1.3
[2.20.02] Heaters CALOMAT 7
Service menu. You only have read access.
The following information is displayed in this menu: Temperature setpoint and actual
temperature values of the measuring block and the membrane.
6.14.2
[2.20.03] Factory calibrations
6.14.2.1
Overview
The following calibrations are grouped under the term "Factory calibrations":
● Signal frequency
● Phase calibration
● Normalization
Factory calibrations may be necessary, for example, after changes to the reference gas.