Siemens SIPROCESS GA700 - Setting Functions;Components of a Digital Output

Functions
6.8 [2.09] Settings > Inputs/outputs
Operating with the Local User Interface
156 Operating Manual, 06/2017, A5E31930478-05
4. Set function or component: "Component" or "Function" parameter box.
Set component and function:
– Table 6-31 Function (pre-selection) "Measuring ranges" (Page 158)
– Table 6-33 Function (pre-selection) "Solenoid valves" (Page 158)
– Table 6-29 Function (pre-selection) "Limit" (Page 157)
Set function only:
– Table 6-26 Function (pre-selection) "Free" (Page 156)
– Table 6-27 Function (pre-selection) "Fault" (Page 157)
– Table 6-28 Function (pre-selection) "Maintenance alarm", "Maintenance demanded",
and "Maintenance required" (Page 157)
– Table 6-30 Function (pre-selection) "Ext. warning limit" (Page 157)
– Table 6-32 Function (pre-selection) "Process tags" (Page 158)
– Table 6-34 Function (pre-selection) "DI links" (Page 159)
– Table 6-35 Function (pre-selection) "Other functions" (Page 159)
5. Set additional digital outputs. Repeat steps 2 to 5.
See also
Setting functions/components of a digital output (Page 156)
6.8.5.4
Setting functions/components of a digital output
Procedures
Table 6- 26 Function (pre-selection) "Free"
Function (pre-
selection)
Purpose/resulting settings
Free
No function. Set one of the following pre-selections or cancel the process.