Siemens SIPROCESS GA700 - Non-Permissibility of Calibrations

Functions
6.7 [2.08] Settings > Calibrations
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05
119
Table 6- 5 Permissibility of calibrations with the following calibration drift messages
Message
No.
Text
[22]
Calibration tolerance exceeded at zero point.
[23]
Validation tolerance exceeded at zero point.
[24] Calibration tolerance exceeded at span point.
[25]
Validation tolerance exceeded at span point.
[29] to [32]
Zero drift MR1 to MR4 outside tolerance.
Table 6- 6 Permissibility of calibrations with the following messages for measured values
Message
No.
Text
[33]
Measured value greater than full-scale value.
[238]
Cross-interference measured value uncertain or faulty.
Table 6- 7 Permissibility of calibrations with the following message for phase calibration or normali-
zation calibration
Message
No.
Text
[27]
Signal frequency changed. Normalization required!
See also
Non-permissibility of calibrations (Page 119)
6.7.2.3
Non-permissibility of calibrations
Overview
The tables below provide an overview of cases in which the execution of a calibration is not
permitted. Information on additional messages and the corresponding remedial measures is
available at:
● → OXYMAT 7 message list (Page 257)
● → ULTRAMAT 7 message list (Page 264)
● → CALOMAT 7 message list (Page 269)