Siemens SIPROCESS GA700 - [3.05.2] Predictive self-diagnostics ULTRAMAT 7

Functions
6.19 [3.05] Maintenance & Diagnostics > Diagnostics values
Operating with the Local User Interface
218 Operating Manual, 06/2017, A5E31930478-05
OXYMAT 7: Status information for the heating control
Table 6- 56 OXYMAT 7: [3.05.1.3] Heating controller
Parameter
Description
Temp. measuring head
Current temperature measured values
Temp. sample chamber
Temp. heating element
Temp. analyzer module
Manip. val. meas. head
Show manipulated value of the measuring head heater
Sample chamber ma-
nipulated value
Show manipulated value of the sample chamber heater
CALOMAT 7: Status information for the heating control
Table 6- 57 OXYMAT 7: [3.05.1.3] Heating controller
Parameter
Description
Measurement block
temp.
Current temperature measured values
Membrane temp.
Temp. analyzer module
Sensor temp.
Block gauge heater
manipulated value
Current block gauge heater manipulated value.
6.19.2
[3.05.2] Predictive self-diagnostics ULTRAMAT 7
Overview
This menu is available only for ULTRAMAT 7 analyzer modules:
Component > "3. Maintenance & Diagnostics" > "05. Diagnostics values" > "2. Predictive
self-diagnostics"
This menu contains status information/current values to evaluate the quality of the signal.
You can also assess whether the device may require service.
You only have read access. The displayed alarm or warning limits can be set with the
Service PIN.