Functions
6.27 [4] Communications
Operating with the Local User Interface
250 Operating Manual, 06/2017, A5E31930478-05
3. Authorize access with Standard PIN.
The parameter display of the MODBUS digital input is opened.
4. Set the trigger: "DI active for" parameter box.
The digital input can be enabled for "High" or "Low" signals.
5. Select function (pre-selection):
– When you select the function (pre-selection) "Free", no additional displays or
parameter fields are shown.
– If you make different function pre-selections, you must assign a function to the digital
input.
6. Assign function: "Function" parameter field.
7. Complete parameter assignment:
Additional display or parameter fields are displayed, depending on the function:
Display/Parameter assignment
Calibration pool Calibration n Parameter assignment of calibration n is dis-
Measuring range
Select component designation
Autom. measuring
...with message refer-
...with message refer-
Enter free text.
Setting digital inputs (Page 148)
Linking digital inputs (Page 150)
MODBUS TCP digital inputs (Page 224)
MODBUS interface for SIPROCESS GA700 (Page 284)
To Next Page
Loading...
Need help?
General
