Siemens SIPROCESS GA700 - Keys with special functions; Cursor and command keys

Operation
4.2 Keyboard
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05
57
Keys with special functions
Table 4- 4 Functions of the keys with special functions
Keys
Function
<MEAS>
If you press the <MEAS> key a single time, the display always
changes to the measured-value display. You log off when you
press it again. You are prompted to accept the changes or to dis-
card them.
<USER FUNC>
Pressing this key calls a user-assigned function.
<CAL1>
Pressing this key triggers the automatic calibration func-
tion "AutoCal1". This function is protected by a password.
<CAL2>
Pressing this key triggers the automatic calibration func-
tion "AutoCal2". The setting options correspond to those of "Auto-
Cal1"
(<CAL1> key). This yields the following additional application
options:
• Operation of two process tags using one device.
• If different calibrations are necessary in each case, you can set
two automatic calibration functions for one process tag.
Cursor and command keys
Table 4- 5 Functions of the cursor and command keys
Keys
Function
<
▲
><
▼
><
◀
><
▶
>
Use these keys to move the cursor in the respective arrow direc-
tion. You can also navigate between and within menu levels.
<ESC>
Pressing this key results in cancellation of the current operation.
You exit the current operation level, for example, a menu of the
navigational view or an editing window of the parameter view.
<ENTER>
Press this key to confirm your input or selection. You open the
currently selected menu entry in the navigational view.