Table of contents
SIWAREX WP231
12 Manual, 07/2014, A5E31238908A-02
Figure 6-1 SIWAREX WP231 connection areas ........................................................................................... 29
Figure 6-2 Shielding in the screw gland ........................................................................................................ 31
Figure 6-3 Shield connection element fitting (example) ................................................................................ 32
Figure 6-4 Connection of strain gauge load cell(s) with 4-wire system ......................................................... 33
Figure 6-5 Connection of strain gauge load cell(s) with 6-wire system ......................................................... 34
Figure 6-6 Connection of Siebert display S102 ............................................................................................. 39
Figure 6-7 Mounting of the calibration protection plate ................................................................................. 42
Figure 7-1 Quick start step 1 ......................................................................................................................... 45
Figure 7-2 Quick start step 2 ......................................................................................................................... 46
Figure 7-3 Quick start step 3 ......................................................................................................................... 47
Figure 7-4 Quick start step 4a ....................................................................................................................... 48
Figure 7-5 Quick start step 5a ....................................................................................................................... 49
Figure 7-6 Quick start step 4b ....................................................................................................................... 50
Figure 7-7 Quick start step 5b ....................................................................................................................... 51
Figure 7-8 Quick setup with marked parameters .......................................................................................... 52
Figure 7-9 Sending/receiving a data record with SIWATOOL V7 ................................................................. 53
Figure 7-10 Layout of the SIWATOOL user interface ..................................................................................... 55
Figure 7-11 Sending/receiving a data record with SIWATOOL V7 ................................................................. 56
Figure 7-12 Trace export ................................................................................................................................. 59
Figure 7-13 Downloading the firmware with SIWATOOL ................................................................................ 61
Figure 8-1 Standstill monitoring ..................................................................................................................... 73
Figure 8-2 Step-forced response of the digital low-pass filter when f = 2 Hz ................................................ 74
Figure 8-3 Calibration digits and calibration weight ....................................................................................... 78
Figure 8-4 Linearizing the scales' characteristic curve .................................................................................. 79
Figure 8-5 Limit value configuration .............................................................................................................. 86
Figure 11-1 Configuration in the TIA Portal "HW catalog" ............................................................................. 146
Figure 11-2 Configuration with S7-1212 CPU ............................................................................................... 147
Figure 11-3 Start address of module in TIA Portal ........................................................................................ 147
Figure 11-4 HW ID of module in TIA Portal ................................................................................................... 147
Figure 11-5 Calling of WP231PR block in user program ............................................................................... 148
Figure 11-6 CMD command mailboxes ......................................................................................................... 149
Figure 13-1 Current ranges for signal level to Namur recommendation NE43 ............................................. 165
Figure A-1 Electrostatic voltages which an operator can be subjected to ................................................... 178
To Next Page
Loading...
