Block library TeleControl ST7
5.7 Master copies
TIM 1531 IRC
144 Operating Instructions, 02/2018, C79000-G8976-C468-02
Reoccurring parameters
Description of the typical parameters
In the following description data point typicals that are identical except for the number of data
points to be processed are described together.
In the tables of the data point typicals you will find the following information about the
individual parameters:
● Parameter
Name of the parameter
● Declaration
Parameter type
– INPUT
Input parameter
– OUTPUT
Output parameter
– IN_OUT
In-out parameter
● Data type
Data type supported for this parameter
● Range of values
● Default
Preset value of the parameter
If you do not program individual parameters of a data point typical the preset value will be
used.
● Explanation
Description of the function and the typical-specific properties of the parameter
Parameters used by many typicals
The following parameters are used by many of the typicals of the TD7onCPU library. These
parameters are described once here and the description is not repeated in the following
sections for the individual data point typicals.
Depending on the use of the typicals, some parameters are programmed differently. Note
the typical use described below.
To Next Page
Loading...
